In the process of driving the bulk feed carrier, speed may be limited, resulting in less torque of the engine. No matter how you step on the accelerator, the speed will not be raised. The following Xiao Bian will analyze the causes of the above imagination.
First, the oil pump is blocked and there is insufficient oil supply. Because the quality of the added diesel oil is not good, it is very easy to cause the pump oil port of the oil pump to be blocked by a large amount of impurities. During normal operation, it is difficult for the oil pump to ensure the normal oil supply of the engine, resulting in only a small amount of diesel oil flowing in the entire oil circuit. In this case, the amount of diesel flow is only enough to start the engine.
Second, only genuine filter can protect the safety of the oil road. Many bulk feed truck drivers think that the filter is almost on the line and does not need to be particularly good. But to know that one problem with the filter cartridge, the seriousness of the problem, not only is it easy to damage the oil system, but can even damage the engine.
Third, the lack of oil pressure, engine speed is limited. Its performance is that after running, dry up the throttle and rotate up to 1800 rpm. Upon inspection, it was found that the rubber gasket on the top of the oil-water separator had aged, and the filter element was almost completely blocked. Moreover, poor quality oil-water separators cannot effectively separate diesel and water.
The better the filter is, the better the quality is. The better the protection of piston rings, oil pump nozzles and other components from clogging and wear.
At present, the heat metering market commonly used heat table is divided into mechanical heat meter(Mechanical Heat Metering) and ultrasonic heat meter.The mechanical heat meters is consist of temperature sensor, flow sensor and calculator. With the aid of the temperature sensor, The Mechanical Heat Meters measure the inlet water and return water temperature. Flow rate sensor measures the volume rate of the hot water in the tube trough the time difference. The figures recorded will be delivered to integral calculator which calculates the total heat and displays.
The mechanical Heat Meters sensors measures the flow rate through the circles of the wheels. According to the specification, The DN can be ≤40mm and ≥50mm. According to the inner structure, the small size mechanical heat meters can be single jet and multi jet. At present, our mechanical heat meters belong to single jet mechanical heat meters and they have higher request from the water quality. According to the counter of the flow sensor, the mechanical heat meters can be dry and wet type. Our mechanical heat meters are the dry type.Except mechanical heat meters,the Plastic Heat Meter is also a good product.
Mechanical Heat Meters
Mechanical Heat Meters,Mechanical Heat Energy Meter,Mechanical Digital Meters,Mechanical Heat Metering,Plastic Heat Meter
Berggruen Technology Co.,Ltd , http://www.meter-technology.com