Open a car with a hand-held gear must learn to judge the road conditions in order to save fuel consumption


Friends who open auto blocks are even more concerned about the additional expenses incurred by themselves. If you can stick to it and use it properly, the automatic transmission is actually fuel-efficient.

Tenderly Starting the Vehicle Actually, there are many common methods of fuel saving for automatic and manual models, such as starting a vehicle. With the accelerated pace of life of the working family, the car's warm-up time is gone. In fact, when the water temperature has not yet reached the normal state, starting the vehicle will be relatively costly; in the cold start warming up the vehicle for about a minute, you can let the car go through a low-load road, wait for the water temperature and oil temperature to rise to the working temperature, and then drive normally. .

Know how to determine the road conditions when we are always attached to the official that a few points of the comprehensive fuel consumption gap, never focus on fuel-efficient personal driving habits, in fact, personal driving habits are the main reason for whether the vehicle is oil-consuming.

For example, driving in the urban areas, we often encounter a continuous red light intersection. In front of the vehicle to see the green light is not willing to give the throttle, slow vomiting, resulting in a lot of vehicles behind can not pass, but also wasted fuel consumption such as idle speed. (Other people's fare is also a waste)

In another case, knowing that the front of the vehicle has just turned on the red light, he still does not stop stepping on the accelerator and rush to grab a more front position. At this time, he must have an emergency brake. Can this be a waste of money? The wise man, seeing the red light in front, will release the throttle and allow the car to naturally slip into the red light waiting area. It may also just wait until the green light is on again. There is no need to stop to wait for the red light.

Parking does not know how to hang the "D" block The most unbearable is when you wait for the traffic lights, the gear has been hanging on the D block, simply can not tolerate, may be a kind of obsessive-compulsive disorder. First of all, if you do this for a short period of time, the impression of the internal parts of the car is not big and it can't cost much oil, but...

If you wait for the traffic lights to hang D block, you go to the phone to go to God, or start to get something, accidentally release the right foot, the car must go forward, then rear-end it, this kind of practical lessons are also many.

Will the gear be hung to the P block? Because the P gear has a gear locking mechanism, this mechanism can realize the parking function. If it is rear-ended, the impact will directly crash the gearbox's locking mechanism. Even if there was less damage at that time, major problems occurred later, and insurance companies would not be compensated.

Ideally, hang the gear to N, then pull the handbrake. This will not only solve the “stopping” function of the vehicle, but also avoid the impact of the external transmission on the transmission. Although this can't save a lot of oil, don't forget that when the D block is at a standstill, the engine still receives the load from the gearbox. Over the long term, the added fuel consumption is also quite a bit.

Stable throttle at high speed Many people think that the automatic transmission has no fuel-efficient advantages at high speeds. In fact, as long as we can stabilize the throttle, we can also control the fuel consumption at a very low level.

Different displacements and different models give different “economy speeds” when running at high speeds. You can use the high-speed friends and you can pay attention to the average fuel consumption value of your car and you will know that your car is at a high speed “economic speed”. . If you find the lowest average fuel consumption at high speeds, you can cruise at this speed.

Xiao Bian believes that most owners who drive the automatic transmission do not generally look at the fuel consumption table, or they may just start watching and they will ignore it. In fact, the method of calculating fuel consumption at a high speed eliminates the tedium of driving an automatic transmission to a certain extent; otherwise, many drivers increase the pleasure of driving an automatic transmission by overtaking, sudden braking, and the like. This will definitely increase vehicle fuel consumption.

Transmission maintenance is also very important In general, the automatic control gearbox internal control mechanism is quite sophisticated, and most of the automatic gearbox oil change cycle in two years or about 4-6 million kilometers. If the gearbox oil does not change to generate grease for a long time, thereby increasing the friction of the precision parts inside, not only increase fuel consumption, but also accelerate the wear of parts.

Tips: When driving on flat urban roads, the gear should always be hung in D, and the automatic transmission will automatically switch between the four forward gears without additional manual operation.

Single Girder Suspension Crane

If you want to spare all the plant space for production,please choose our single girder Suspension Crane.The suspension crane can be directly installed on the roof of existing plants without brackets to save space and cost for customers. The running limit dimension for trolley of the electric suspension crane is small.The heavy object can be lifted to the position very close to the ground of plant.The running range of trolley will exceed the span of crane through the side jib.

Single Girder Suspension Crane,Single Girder Under Running Crane,Single Under Running Bridge Crane,Electric Single-girder Suspension Crane

Eurocrane (China) Co., Ltd. , https://www.overhead-crane.com