Prevention of carbon deposition in 11 commercial vehicles:
1. The carbon deposition in the 11-seater commercial vehicle is caused by impurities in the gasoline. Therefore, the carbon deposition caused by the use of clean gasoline will be greatly reduced. However, it needs to be noted that the gasoline number of the vehicle is not used to represent quality, but is used to represent octane number, so the label cannot prove the cleanliness of gasoline and is a problem of quality. In order to better protect the cleanliness of gasoline in commercial vehicles, some drivers’ friends will use gasoline cleaners to add gasoline to gasoline. This will prevent carbon deposition on the surface of the metal surface, and also prevent carbon deposition. The carbon particles can be activated and gradually removed, so that the effect of protecting the engine can be achieved.
2. Note the timing of the stalling of the 11 commercial vehicles. If the idle time is longer, then the time required for the vehicle's engine to reach the normal working temperature will also become longer, and gasoline will be sprayed. The evaporation rate required after the back of the valve will also become slower. This way of operating the vehicle will also intensify the production of carbon deposits. When driving an 11-seater commercial vehicle at idle speed, the engine air flow that can enter the vehicle will also become smaller. This situation is very unfavorable for the erosion of carbon deposits.
3. Those vehicles equipped with turbochargers should not be turned off immediately during high-speed driving or when driving to a section requiring climbing. Instead, they can choose to turn off the engine after running at idle speed for ten minutes, because the turbocharged vehicles that are installed have a much faster carbon deposition rate than those naturally aspirated vehicles. When entering the conventional maintenance stage, 11 business vehicle drivers’ friends must do a good job of cleaning the air intake system of the commercial vehicle. Before disassembling the engine of the vehicle, they can use some special equipment or It is a way to say that the eleven business vehicles' oil routes, valves, and air intakes are relatively easy to clean up the key parts of carbon deposition.
The Y83 series Briquetting Machine is a vertical single master cylinder metal briquetting machine with a master cylinder pressure of 6300KN. This machine is also equipped with an automatic feeding system.Y83 series Briquette Machine is mainly used to directly cold-press metal raw materials such as cast iron scraps, steel scraps, copper scraps, aluminum scraps, and high-quality mineral powder into 3-6 kg cylinders or other shaped cakes through high pressure, so as to facilitate storage. Transportation and reduce the loss of transportation and smelting in the process of recycling and reuse.Our scrap metal recycling machinery can be customized according to customer needs.
Features
1. The electrical part adopts imported PLC automatic control system, which has strong anti-interference ability and low failure rate.
2. The body adopts the overall steel structure, which has high strength and good stability, and does not need to install anchor screws.
3. The machine adopts hydraulic transmission, highly professional integral valve block, and large flow diameter, which reduces the pressure loss of the system and eliminates the drawback of leakage.
4. The use of cartridge valve, electro-hydraulic proportional valve and unique oil circuit design make the hydraulic system perfect, even if it works under long-term heavy load, the system will not be powerless.
Vertical Briquette Machine,Vertical Briquette Press,Vertical Brick Maker,Vertical Screw Briquette Machine
Jiangsu Dalongkai Technology Co., Ltd. , https://www.dlkscrapbaler.com