Since the protector is a bimetal protector, although it has a good effect on the slow overload protection of the temperature rise, it has little effect on some cases where the temperature rise is severe in a short period of time. A large current is used to protect it. The thermal characteristics of the protector have a lag time for high current protection. In the stall state, the motor is blocked, and the adiabatic process is similar. The pressure and temperature in the closed chamber will increase rapidly at the beginning; at the same time, because the gas on the suction side is not replenished, the flow rate is also smaller (similar to vacuuming), compression. The work is reduced, and the pressure and temperature rise rate are slowed down. After about 1min, the temperature in the chamber can reach 250e, and the current is basically stable at the minimum value of 212A. At this time, the compression work tends to zero. The closed cavity of the compressor mainly relies on motor heating and mechanical friction to generate heat, which leads to temperature increase. The pressure also rises and the rate of increase does not change until the pressure reaches the stall condition.
The compressor motor is a single-phase asynchronous AC motor, which is operated by a capacitor running type. The maximum torque of the motor running is generally about 250 of the full load. When the load is too large, the compressor stalls. After the motor stalls, the compressor is blocked, the motor coil is heated, and the motor heat is increased sharply. The maintenance time is about 10s. At this time, the heating process is constant. At the beginning of the stall, more flammable and explosive gases have accumulated in the compressor, and the high temperature and high pressure in the closed chamber of the compressor greatly accelerate the decomposition and cracking of the motor insulation material. After the stall occurs, a large current flows through the motor coil. Once the insulation is weakened somewhere, the motor is prone to short circuit or high voltage discharge to generate sparks. The electric spark is a kind of external high-temperature heat source, so that the temperature of the local combustible mixture close to it rises to a critical state and is ignited by the fire, and then the flame is propagated to cause the entire mixture to ignite and ignite.
The baby grows up day by day, and likes swimming every day. In order to continue the project of baby swimming, the baby's head can also be raised at that time, and he no longer likes to be strangled by the neck. The baby also needs a wider field of vision. The depth of the baby swimming pool cannot reach the purpose of the baby's swimming (the baby's feet touch the bottom of the pool). If you want to swim in the original baby swimming pool, you must increase the baby's swimming height or increase the depth of the pool. The neck is moved to the base of the thigh, which increases the height of the baby's swimming. In order to solve these two problems, the Inflatable Baby Swim Seat was created.
The Inflatable Baby Swim Seat has multiple independent airbags, and there is an anti-leakage device in the air nozzle, which is safe and reliable. The swimming ring is carefully designed, made and comfortable to wear according to the characteristics of the baby's thigh. Proper use can prolong the use time.
Inflatable Baby Swim Seat,Baby Swimming Pool Floats,Baby Pool Floats,Infant Pool Float With Canopy
P&D Plastic Manufacture Co., Ltd , https://www.jminflatablepool.com