The advantages of the piston air compressor are simple structure, long service life, and easy realization of large capacity and high voltage output. The disadvantage is that the vibration is large, the noise is large, and because the exhaust gas is intermittent, the output is pulsed, and a gas tank is required. What should I pay attention to when using an air compressor? The following Linked Hardware Wholesale City summarizes the following items: ![]()
Operating specifications:
1. Air compressor lubricating oil generally has high oil quality and contains oxidizing agent. It is not easy to oxidize and deteriorate, it is not easy to foam, and the residual carbon content is high. The flash point is ideal. Due to the wide variety, common Commonly used are:
a 13" compressor oil (winter oil)
b 19" compressor oil (summer oil)
2, please keep the oil surface in the red circle in the middle of the oil mirror. If you add too much oil, you will waste the lubricating oil, and it will make the gas valve carbon. If you add too little oil, it will often cause poor lubrication, which will cause it to burn or wear. Should be kept in the red circle at any time.
3. When the oil color becomes black or there is oil pollution (about 500 hours after each use), please change the oil once.
4. When changing oil, please unscrew the drain plug under the crankcase first, and then export the dirty oil with cardboard or other utensils. After the oil is cleaned, tighten the oil plug (preferably on the oil bolt) Universal glue or stop bleed to prevent oil leakage), re-add new oil to the oil mirror red circle when opening the fuel filler cap
5. Do not add new oil during operation.
6, avoid using concentrated lubricants and other miscellaneous oil waste oil.
Precautions:
1. Check the screws or nuts of each part for looseness.
2. Is the belt tight?
3. Is the pipeline normal and the oil level is suitable?
4. Is the wire and electrical switch in compliance with the regulations and the limits are correct?
5. Whether the fulcrums of each wheel have been fixed or stable.
6. Compression is whether the pulley is easily rotated by hand.
7. Before the compressor works, it is best to idle for 2 to 3 minutes or more, and then operate normally.
8. Check whether the running direction is the same as that of the pointing arrow. If it is not the same, please replace any two of the three power supplies with the three-phase motor.
9, the air cleaner should always check whether there is pollution, the filter cotton should often be removed for cleaning (with gas oil) or replacement, in order to maintain a good air filtration effect.
10. After the air compressor is used daily, the bucket drain valve should be unscrewed to remove the condensation water and oil in the barrel.
11, air compressor cylinder head and copper tube part, due to air compression and heat, the general temperature is very high, this is an inevitable phenomenon is not abnormal.
12. If the air compressor is in power or after use, please cut off the power to ensure safety.
The QNP Steam Turbines` capacity mainly covers 200MW and below. Our normal impulse turbines are flexible and diverse in structure and layout so as to meet various requirement of our users. Aiming at the global leading equipment manufacturing enterprise, our design and R&D standards are higher than GB standard and in the same league with European and American energy equipment manufacturers.
Condensing Steam Turbine, Back Pressure Steam Turbine
Shandong Qingneng Power Co., Ltd. , http://www.qnpturbines.com