Discharge Safety Operation Regulations for Powdered Material Vehicles

1. Before each time the material inlet is opened, the pressure relief valve and the inlet valve must be opened. After the remaining gas in the tank is removed, the lid is opened to avoid injury.

2, always pay attention to whether the pressure gauge is working properly, prevent the failure of the pressure gauge, overpressure, and the explosion of the tank exploded.

3, often check the safety valve, to ensure pressure relief at 0.2Mpa, the tank body pressure shall not exceed 0.2Mpa.

4, often check the operating table is working properly, so as to avoid over-rotation and damage to the air compressor and power take off (specifically refers to the powder tank bicycle).

5. Always listen to the sound of the PTO and air compressor. If there is abnormal sound, stop the machine immediately to eliminate the malfunction.


Aluminum Extrusion Sheet

Our extrusion Aluminum Sheet widely use in the heat exchange field, for water cooling and liquid cooling area. Size:Customized. Thickness: Customized. Technical: CNC, Welding, Extrusion.Aluminum Extrusion Sheet is limited in size,width around 20cm to 30cm,thickness 10mm,but length can be very long.Bring technology to the ground by material.Material innovation,Trumony Aluminum Limited is always on the road.

aluminum extrusion sheet, aluminum extrusion plate, extrusion aluminum sheet, aluminum extrusion panel

Trumony Aluminum Limited , https://www.szaluminumplate.com